Hach-Lange SC 60 - Manual (Page 32)

28
Operation
The display will flash on startup, when a sensor error has occurred,
when the hold outputs function has been activated, and when a
sensor is being calibrated. An active system warning will cause the
warning icon (a triangle with an exclamation point inside) to be
displayed on the right side of the display. See
Figure 23 .
4.2.1 Important Key Presses
• Press HOME then RIGHT or LEFT to display two readings when
the sensor is connected. Continue to press RIGHT or LEFT to
toggle through the available display options:
• Press UP and DOWN to toggle the status bar at the bottom of
the measurement display to display the secondary
measurement (temperature) and output information.
• When in Menu mode, an arrow may appear on the right side of
the display to indicate that more menus are available. Press
UP
or DOWN (corresponding to the arrow direction) to display
additional menus.
Figure 23 Display Example
1 Status bar. Indicates the sensor name and status of relays. The
relay letter is displayed when the relay is energized. 4 Parameter
2 Main measurement 5 Warning icon area
3 Secondary measurement (if applicable) 6 Measurement units
7.00
SENSOR NAME:
pH
TEMP: 23.0°C
1
2
3
6
5
4
pH pH pH
7.00
SENSOR NAME:
TEMP: 23.0°C
7.00
SENSOR NAME:
OUTPUT1: 12.00 mA
pH
7.00
SENSOR NAME:
OUTPUT2: 12.00 mV
pH pH
SENSOR DIAG
SENSOR SETUP
TEST/MAINT
MAIN MENU
SYSTEM SETUP
OUTPUT SETUP
SYSTEM SETUP
NETWORK SETUP
RELAY SETUP
DISPLAY SETUP
DISPLAY SETUP
SYSTEM SETUP
LOG SETUP
SECURITY SETUP
CALCULATION
SECURITY SETUP
SYSTEM SETUP
CALCULATION
LOG SETUP
ERROR HOLD MODE