Asus TS300-E5 - Manual (Page 192)

7-6 Chapter 7: Driver installation
7.1.3 Installing the RAID controller driver (for PA4 Model)
Windows ® Server
During Windows ® Server installation
To install the RAID controller driver when installing Windows ® Server:
1. Boot the computer using the Windows ® Server installation CD.
2. Press <F6> when the message “Press F6 if you need to install a third
party SCSI or RAID driver...” appears at the bottom of the screen.
3. When prompted, press <S> to specify an additional device.
5. Do one of the following actions:
• On a Windows PC – Type rawrite.exe to extract the driver image file to
the blank diskette.
• On a Linux PC – Type dd if=<imageFileName> of=<floppyDeviceName>
bs=10k to extract the driver image file to the blank diskette.
Where <imageFileName> is the driver image file name and
<floppyDeviceName> is the device name, such as /dev/ fd0.
S=Specify Additional Device ENTER=Continue F3=Exit
Windows Setup
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices(s):
<none>
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.