Installation – CTI Products RCD Advanced Client-Server User Manual
Page 14
14
68-11824-210
Installation
Installation Overview
The installation of the MCN Server software and network interfaces are done in the following order:
1)
If PCLTA network interface will be used, install the PCLTA device drivers and network interface
card, then test the interface. See PCLTA Network Interface Installation (If needed) below.
2)
Run setup.exe on the MCN Server PC to install the MCN Server software. See Installing MCN
Server Software on page 20 in this section.
3)
Run the MCNConfig program to customize the MCN System Resources and display windows for
your system.. See MCNConfig Program on page 37.
4)
If you are using HIB-IP units, program them using MCNConfig program. See Programming HIB-
IP Units on page 52.
5)
Install the Security Hardware Key in a USB slot on the MCN Server PC.
6)
Run the MCN Server program on the MCN Server PC. See MCN Server Program on page 136.
You will be asked to enter the MCN Software Key and IP parameters on the first use.
7)
Run setup.exe on the MCN Client PCs to install the MCN Client program. See Installing MCN
Client on page 33 for details.
8)
Run the MCN Client program on the Client PC(s). See MCN Client Program on page 151.