CTI Products RCD Advanced Client-Server - Manual (Page 26)

Installation
26 68-11824-210
HW Setup - PCLTA Setup
If a PCLTA board (and its driver) is properly installed in your PC, the HW Setup program will detect it
and present it in the Possible Types list box.
In the unlikely event that you have multiple PCLTA boards installed in your PC, you can select one of
them to use. The MCN Standard Server program supports only one Network interface at a time.
•
Select the PCLTA and click the Add NI button.
The Group/Module address defaults to “F0/10” during installation.
•
Change the Group and Module address as required for your system.
•
Click the OK button.
Important: MCN Address Setting
Each PC and each MCN module in the system must have a unique address. If you are setting up
multiple PCs, be sure to set up each PCLTA card with its own address.
If you have a Custom Engineered System (with custom system documentation part number
KA-8xxxx-xxx), be sure to set the PCLTA address to the Group & Module numbers shown in your
documentation. Failure to do so may cause the system not to work
•
In the above window, click the OK button.