CTI Products RCD Advanced Client-Server - Manual (Page 16)

Installation
16 68-11824-210
Click on the Yes button to display the “Setup Complete” window as shown below.
Click on the Finish button. The following window will provide a selection for restarting the computer.
Select “NO, I will restart my computer later”, then click the Finish button.
During the PCLTA device driver installation, the following line is added to the config.nt file to provide
a driver for DOS applications:
device=%SystemRoot%\system32\pcltdos.sys /D1
Finally, power down the computer so that the PCLTA network interface card can be installed.
Install PCLTA Network Interface Card
The PCLTA device drivers must be installed prior to installing the card. If the drivers have not been
installed, complete the previous step.
To install a PCLTA card into your PC, follow these steps:
1. Turn off the PC and remove the power cord.
2. Open the PC case and locate an empty slot.
3. Remove the corresponding blank panel from the rear of the PC.
4. Insert the PCLTA card into the slot, ensuring that the edge connectors are fully mated, and the
slot in the rear panel-mounting lug of the PCLTA is aligned with the threaded hole in the PC
chassis.
5. Replace the screw to hold the PCLTA firmly in place.