Controlled Products Systems Group 790919 - Manual (Page 9)

Page 9
November, 2003
455 D Control Panel Installation Instructions
ADVANCED PROGRAMMING
+
Display Function Default
M AXIMUM T ORQUE AT I NITIAL T HRUST :
The motors operate at maximum
torque (ignoring the torque setting)
at start of movement. Useful for
heavy leaves.
4 = Enable
No = Disabled
L AST S TROKE AT C LOSING :
The motors are activated at full
speed for 1s to facilitate locking of
the electric lock.
4 = Enable
No = Disabled
R EVERSING S TROKE :
Before opening, while the gate is
closed, the motors thrust to close
for 2 s thus facilitating release of the
electric lock.
4 = Enable
No = Disabled
L EAF 2 O PENING D ELAY (2 S ):
Enables delayed start (at opening) of
leaf 2, avoiding interference between
leaves.
4 = Enable
No = Disabled
F AIL S AFE :
If this function is activated, it
enables a function test of the
ph ot ocel l s b e for e an y g at e
movement. If the test fails
(photocells not serviceable), the gate
does not start the movement.
4 = Enable
No = Disabled
P RE F LASHING (5 S ):
Activates the flashing lamp for 5s
before start of movement.
4 = Enable
No = Disabled
E LECTRIC L OCK ON L EAF 2:
For using the electric lock on leaf 2
instead of on leaf 1.
4 = Enable
No = Disabled
F +
Display
Function Default
I NDICATOR -L ICHT :
If 0 is selected, the output functions
as a standard indicator-light (lighted
at opening and pause, flashing at
closing, and off when gate closed).
Different figures correspond to timed
activation of the output, which can be
used (via a relay) to power a courtesy
lamp. Time can be adjusted from 0
to 59s in 1s increments, and from 1.0
to 4.1 min. in 10s steps.
0 = Standard Indicator-Light
From 1 to 4.1 = Timed Output
C LOSING P HOTOCELLS REVERSE AT
RELEASE :
Enable this function if you want the
closing photocells to stop the gate
movement and reverse it after the
beam is cleared. Default setting is
immediate reverse.
4 = Enable
No = Disabled
A.D.M.A.P. F UNCTION :
If this function is enabled, the safety
devices operate in compliance with
French standard NFP 25/362.
4 = Enable
No = Disabled
A SSISTANCE R EQUEST ( COMBINED WITH
NEXT FUNCTION ):
If activated, at the end of countdown
(settable with the next function, i.e.
“Cycle programming”) it effects 8s of
pre-flashing at every Open pulse (job
request). Can be useful for setting
scheduled maintenance jobs.
4 = Enable
No = Disabled
C YCLE P ROGRAMMING :
For setting count down of system
operation cycles. Settable (in
thousands) from 0 to 99 thousand
cycles. The displayed value is
updated as cycles proceed. This
function can be used to check use of
the board or to exploit the
“Assistance Request” function.
E XIT P ROGRAMMING :
Exit from programming and return to
display of inputs status.