Pach and Company AeGIS 4000P Manual - Manual (Page 36)

AeGIS 4000P QUICK REFERENCE GUIDE
TWO WAYS TO LOG IN TO PROGRAMMING MODE
1. Press 0 # simultaneously then release, enter the 4-digit master code. Default master code = 0000.
A short beep if the master code is valid or a long beep if the master code is not valid or
2. Press on board round black button then then select the function code from the table.
SYSTEM OPERATION
TO CALL: Press #
TO GRANT ACCESS TO A VISITOR:
Press 9 (relay 1) or press 8 (relay 2)
TO USE ACCESS CODE:
Press * then 4-digit acces code.
TO ESTABLISH TWO WAYS
COMMUNICATION WITH THE SYSTEM
FROM PREMISE
(see function code 98) :
Press # # or * *, one beep, then press * to
eastablish two ways communication.
TO ESTABLISH TWO WAYS COMMUNI-
CATION WITH THE SYSTEM FROM
REMOTE SITE
Call the system’s phone number, hear one
beep then press *
TO EXTEND TALK TIME:
Press # after the time out warning beep
TO ENABLE /DISABLE CALL
FORWARDING:
LOCAL:
Enable: Press 0*, then 1 (71) or 2 (72)
Disable: Press 0* then 0
PREMISE PHONE (see function code 98) :
Enable: Press # # or * *, one beep, then
press 1 (71) or 2 (72)
Disable: Press # # 0
UNLOCK CYCLE, UNLOCK HOLD,
CLOSE DOOR:
LOCAL:
Press 0 # simultaneously then release,
enter the 4-digit master code, then select
90 or 91, see table, then press #
PREMISE:
Press # #, one short beep, then press
9 ---- Unlock cycle relay #1 (open and close
door)
8 ---- Unlock hold relay #1 (open and hold
open door)
7 ---- Lock relay #1 (close door)
5 ---- Unlock cycle relay #2 (open and close
door)
4 ---- Unlock hold relay #2 (open and hold
open door)
REMOTELY RELEASING THE DOOR (function code 96 must be set 1-9 rings) Call the system (must know the system’s
phone number), press # and 4 digit master code. Press * then
9 ---- Unlock cycle relay #1 (open and close door1)
8 ---- Unlock cycle relay #2 (open and close door 2)
CALL WAITING , Function code 96 must be set 1-9 rings. Call waiting beep will be heard, Press 0 to transfer between the
two calls