PROLiNK PIC1007WP User Manual - Manual (Page 16)

1.9. Advanced Network
In some special situation, your network environment only provides PPPoE connection (ADSL service); there is
no NAT/router available. You will then need to set the PPPoE settings in the “Advanced Network” page. Only the
PPPoE username and password are needed to let PPPoE work. After the “Save & Apply” button is pressed, the
PPPoE function will work immediately. You can check the “Registration status” in the “Information” page to see
if the IP Camera is registered using the PPPoE connection.
Please take note that the DHCP or static IP settings in the “Network” page can work together with the PPPoE
connection. Only that the PPPoE has higher priority, so, if the PPPoE is working, the IP Camera will use PPPoE to
connect to the Internet.
The default setting is “Disable PPPoE”.
Figure 3-10: Advanced network settings page
1.10. Video Settings
The IP Camera is designed to provide high quality video for viewing from LiveView Software. In this page,
you can modify some settings related to the video viewing:
1. Password (play video) – this is the password needed for viewing the video from IP Camera
Together with the IP Camera ID, you can view the video of this IP Camera anywhere in the world through
the Internet.
2. Internet speed – this is the Internet bandwidth of your network environment. Higher value will
generate higher video quality. But if your internet connection cannot provide more bandwidth than the
specified value, the video quality could degrade. Set this value lower than your internet bandwidth.
3. Select resolution & frame rate automatically – you can let the system select the suitable video
resolution and frame rate automatically for you. The selection is based on the “Internet speed” value.
This is the recommended default setting.
4. Resolution – 320x240/640x480/1024x768/1280x800. If you decide to choose the value manually, you
can choose one of the values. However, If the Internet speed is slow (low value), setting high resolution
(1280x800) or frame rate could cause very bad video quality.
EN 16