PROLiNK PIC1007WP User Manual - Manual (Page 21)

1.14. Speaker Alarm Settings
The IP Camera provides Speaker Alarm function that act like a conventional alarm siren. Any PIR or motion
detection could trigger the speaker alarm.
1 1. Speaker alarm trigger– select the trigger mode of the speaker alarm
a. A. Motion trigger – if this is selected, the speaker alarm signal will be active
when video motion is detected. The detection sensitivity is set In the “motion
detection” page.
b. B. PIR trigger – if this is selected, the speaker alarm will work when the PIR
sensor is detected..
c. C. Schedule – if this is selected, the speaker alarm is scheduled according to the
settings of scheduling in section 1.18.
d. D. Disable–disable the speaker alarm.
2 2. Alarm loop times – this is the duration the speaker alarm will be active during alert.
1.15. NAS Settings
The IP Camera provides recording of video files into a standard NAS (Network Access Storage) device. The IP
Camera connects to NAS device using the standard LMX_NS/CIFS/SSN protocols which are the same as the
Microsoft Windows network neighborhood protocols. This allows the posibility to record video files to all
standard NAS devices in the market. Since there are a lot of different choices, including price and scale, user
can decide which is best for their needs. By using this function, a standard NAS device will become a NVR
(Network Video Recorder) device.
Notice
When the IP Camera is doing NAS recording, this is counted as one video user. Please refer to appendix B
for maximum simultaneous users.
1. If the “Always Recording” is selected, the system will start to record continuously to the NAS storage
device. If the “Schedule Recording” is selected, the IP Camera will record according to the schedule set
in section 1.18. “Disable Recording” will disable this NAS recording.
2. When the NAS is recording, the system will check the free disk space available. If the free disk space is
less than the specified number, the system will do “Circular recording” (overwrite the oldest recorded
files in the NAS device) or “Stop recording” depending on the option selected.. If the “keep recorded
video for xx days” is selected, the system will do circular recording and over write the recorded video files
older than xx days ago.
3. The IP Camera can connect to the NAS device by using the “NAS name” or “NAS IP address”. If the NAS
device and the IP Camera are in the same local area network, the IP Camera can automatically locate and
connect to the NAS device by the “NAS name”. If the NAS device uses a fixed IP address (either in the
local area network or in the public internet), the IP Camera can connect to it by the “NAS IP address”.
4. The “Shared folder name” is the folder in the NAS device that will record the video files of the IP Camera.
Figure 3-16: Speaker Alarm setting page
EN 21