Setting the scsi ids – ADIC Scalar Series User Manual
Page 21
Getting Started
11
Setting the SCSI IDs
Your Scalar Library consists of up to five SCSI devices; four drives and the library robotics. The library can be
connected to from one to five separate SCSI buses. Each device in your library must be set to a unique ID for the
SCSI bus it is connected to. The ID for the robotics is set by selecting it through the Operator Panel, Off-Line
Mode, Configuration Menu, Set SCSI ID option (see sub-subsection Set SCSI ID, subsection Configuration Menu,
section Off-Line Mode Menus in Chapter 4: Equipment Description of this manual). The IDs for the drives are set
by selecting the appropriate ID on the rotary switch on the back of each drive assembly.
Library
SCSI I/O
Connectors
Drive
SCSI I/O
Connectors
Drive
SCSI ID
Rotary
Switches
Drive SCSI ID Rotary Switches