ADIC Scalar Series - Manual (Page 25)

Connecting the Scalar 448 15
The following table provides several examples of SCSI configurations:
If you have this many SCSI buses... Use this configuration...
1 1
2 2
3 3
4 4
5 5
Install the SCSI cables, terminators, and jumpers as indicated by the configuration illustration.
p Check that the power switches on both your Scalar Library and your host computer are off.
The following symbols are used in the SCSI configuration illustrations:
SCSI
Terminator
SCSI Jumper
Legend
C
Host Computer
SCSI Cable to
T J
Configuration Legend
J
Drive 3 Drive 2 Drive 1 Drive 4
Library Robotics
J
J J T
C
SCSI Configuration 1 — One SCSI Bus