ADIC Scalar Series - Manual (Page 37)

Equipment Description 27
Initialize Map Slots
Enables/disables the mapping of the storage slots whenever the Scalar Library is powered-up, after the front door
has been opened and then closed, or if a SCSI bus Reset occurs
p To disable the mapping of slots use the UP or DOWN keys to select "N". Press ENTER to execute the
change.
Note
Init Map Slots default setting is Y.
Note
Disabling Init Map Slots by selecting “N” will force Init Scan Barcodes
to “N” ( see below).
Initialize Scan Barcodes
Enables/disables the scanning of the cartridge barcodes whenever the Scalar Library is powered-up, or after the
front door has been opened and then closed. The application software overrides the setting of this parameter. If
Barcode Scanner configuration is set to No, Initialize Scan Barcodes is ignored, and the barcode reader is not
available to the application software.
p To disable the scanning of barcodes use the UP or DOWN keys to select "N". Press ENTER to execute the
change.
Note
Init Scan Barcodes default setting is Y.
Note
Enabling Init Scan Barcodes by selecting “Y” will force Init Map Slots
to “Y” ( see above).