Reese 37069 MULTI-FIT RECEIVER - Manual (Page 4)

TOOLS REQUIRED
3/4” SOCKET
3/4” WRENCH
9/16” SOCKET
9/16” WRENCH
21MM SOCKET
TORQUE WRENCH
TOOLS REQUIRED
3/4” SOCKET
3/4” WRENCH
9/16” SOCKET
9/16” WRENCH
21MM SOCKET
TORQUE WRENCH
1/2” CARRIAGE BOLT
1/4” BOLT PLATE
1/2” CONICAL WASHER
1/2” NUT
3/8” BOLT
3/8” FLANGE NUT
EXISTING 14MM BOLT
1/2” CARRIAGE BOLT
1/4” BOLT PLATE
1/2” CONICAL WASHER
1/2” NUT
3/8” BOLT
3/8” NUT
3/8” LOCK WASHER
EXISTING 14MM BOLT
1999-2005 CHEVY SILVERADO & GMC SIERRA (SHORT BEDS):
1. Remove the 14mm bolt from the bottom of the frame with a 21mm
socket.
2. Bolt the brackets on with the 14mm bolt that was just removed into
the hole shown. Insert a 1/2” bolt with a 1/4" bolt plate through the
large hole in the frame and into the bracket as shown. Install 1/2”
conical washers, and nuts on the bolts. Leave the bolts loose.
3. Install the center section between the brackets as shown. Use the
bolting location indicated. Install 3/8” bolts through the center section
and the bracket as shown. Install 3/8” flange nuts on the bolts.
NOTE: Be sure to use four holes to bolt the brackets to the center
section.
1999-2005 CHEVY SILVERADO & GMC SIERRA (LONG BEDS):
1. Remove the 14mm bolt from the bottom of the frame with a 21mm
socket.
2. Bolt the brackets on with the 14mm bolts that were just removed.
Insert a 1/2” bolt with a 1/4" bolt plate through the large hole in the
frame and into the bracket as shown. Install 1/2” conical washers,
and nuts on the bolts. Leave the bolts loose.
3. Install the center section between the brackets as shown. Use the
bolting location indicated. Install 3/8” bolts through the center
section and the bracket as shown. Install 3/8” flange nuts on the
bolts. NOTE: Be sure to use four holes to bolt the brackets to the
center section.
4. Tighten the nuts in the following order:
First torque the 3/8" nuts to 35 ft•lb.
Then torque the 1/2" nuts to 70 ft•lb, and the 14mm bolts to 85 ft-lb.
FRONT
REAR
FRONT
REAR
PICTURE ABOVE DOES NOT SHOW INNER MOUNTING BRACKET ON CROSS TUBE FOR CLARITY - SHOWN ON PAGE 9
4. Tighten the nuts in the following order:
First torque the 3/8" nuts to 35 ft•lb.
Then torque the 1/2" nuts to 70 ft•lb, and the 14mm bolts to 85 ft-lb.
PICTURE ABOVE DOES NOT SHOW INNER MOUNTING BRACKET ON CROSS TUBE FOR CLARITY - SHOWN ON PAGE 9
4