Rivers Edge RE619 LumberJack Extrme - Manual (Page 16)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 16
Operator's Manual
Rivers Edge One-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE607)
Tools needed – two 7/16" wrenches
iMpoRtant aSSEMblY tip: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the foot platform (48045) to the inside of side rails (1ML24) using (2)
provided 1/4-20 x 2-1/4” bolts and locknuts. SEE fIGuRE 1. DO NOT tighten
all nut & bolt assemblies completely!
notE: Mesh surface should be on top with squared ends of platform
closest to side rails.
2. Attach the tree blade frame (1ML34) to the inside of side rails, and the (2) shooting
rail mounts (112ML43) and (2) armrests (LFX5) to the outside of side rails using
(4) provided 1/4-20 x 3-1/4" bolts, locknuts and steel washers. SEE fIGuRE 2A.
3. Attach seat frame (1ML15) to the tabs on the tree blade frame using (2)
provided 1/4-20 x 1-1/2” bolts, locknuts, nylon washers and (4) steel washers.
SEE fIGuRE 2B. Attach the (2) provided rubber bumper stops to top side
of tree blade frame by pressing in to provided holes. SEE fIGuRE 2B.
notE: Mesh surface of seat frame should be on top.
notE: nylon washers should be placed between tabs and seat frame to
eliminate noise.
Figure 1
cutout view
of foot platform
1/4-20 x 2-1/4”
bolts locknuts
side rails
Figure 2A
1/4-20 x 3-1/4” bolts
locknuts
steel washers
Figure 2B
locknuts
tree blade frame
seat frame
1/4-20 x 1-1/2” bolts
rubber bumpers
tabs
nylon washers
steel washers
steel washers
tree blade frame
side rails
shooting rail mounts
armrests