Rivers Edge RE619 LumberJack Extrme - Manual (Page 33)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 33
Operator's Manual
Rivers Edge One-Man Ladder Stands
21. Attach the (2) support braces (410024) to the outside of platform
J-pipes and outside of top ladder section w/ mounting holes using
(4) provided 1/4-20 x 1-1/2” bolts and locknuts. SEE fIGuRE 13.
Tighten securely. Be sure not to over tighten or crush tubing
when tightening!
22. a. Attach the stabilizer bar extension tube (1ML23) to the second
ladder section mounting bracket using (1) provided spring lock
pin. SEE fIGuRE 14.
b. Slide the stabilizer bar (L17) into the extension tube and attach
the two pieces together using (1) provided spring lock pin. Spring
lock pin must go through both the extension tube and
stabilizer bar at appropriate hole to achieve desired distance
from tree. Adjustment in length may be needed when ladder is
uprighted later in instructions. SEE fIGuRE 14.
23. Tie one end of each of the provided 15’ ropes to the platform J-
pipes, just in front of the tree blade (2ML130). Be sure your double
knots are secure. SEE fIGuRE 15.
Figure 13 Figure 15
Figure 14
24. a. Attach the removable seat pad (360005) to top of mesh fabric
on assembled seat frame. Wrap the Velcro straps or buckle straps
around seat frame and secure together. Pull straps tight so seat is
not loose.
b. Attach the (2) provided 9” camo sleeves (48736) to the armrest
tubes by wrapping around metal tubing and attaching Velcro
together.
c. Attach the provided 12” foam pads to the top of door frames
and curtain rail side tubes at desired locations.
d. Attach both halves of the camo curtain to the assembled shoot-
ing rail/door assembly. Each half has a “pocket” type feature sewn
on the inside, this portion is where the upper side of the door
frames are inserted into. The elastic side of each curtain should
be secured around the platform. Secure the remaining portions
of each curtain half by attaching Velcro points to the shooting rail
assembly and platform.
support braces
1/4-20 x
1-1/2" bolts
stabilizer bar
stabilizer bar
extension tube
spring lock pin
locknuts