Rivers Edge RE619 LumberJack Extrme - Manual (Page 28)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 28
Operator's Manual
Rivers Edge One-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE624)
Tools needed – two 7/16” wrenches, rubber mallet
iMpoRtant aSSEMblY tip: do not tiGhtEn nut & bolt coMbinationS
coMplEtElY until all paRtS aRE aSSEMblEd toGEthER! FinGER tiGht-
En onlY pluS onE tuRn oF a WREnch onlY! thiS Will tEMpoRaRilY hold
thE lock nut on thE bolt WhilE hElpinG aliGnMEnt oF all paRtS!
aFtER all paRtS aRE aSSEMblEd toGEthER, all nut & bolt coMbina-
tionS MuSt bE coMplEtElY tiGhtEnEd!
1. Attach the (2) platforms together using (2) provided 1/4-20 x
2” bolts, locknuts and steel washers. SEE fIGuRE 1. DO NOT
tighten all nut and bolt assemblies completely!
2. Attach the (2) platforms (410000) to the platform J-pipes (410003)
using (8) provided 1/4-20 x 2-1/4” bolts, locknuts and steel wash-
ers. SEE fIGuRE 2.
notE: Mesh surface of foot platforms should be on top.
3. Attach the tree blade weldment (2ML130) to the platform J-pipes
using (2) provided 1/4-20 x 2-1/2” bolts, locknuts and steel wash-
ers. SEE fIGuRE 2.
4. Attach the (2) seat upright weldments (410005) to the platform
J-pipes using (4) provided 1/4-20 x 1-1/2” bolts and locknuts. SEE
fIGuRE 3.
5. Attach the seat upright loop (410023) by inserting each end into
the seat upright weldments. Secure these parts together along
with the (2) armrest straps (410103) using (2) provided 1/4-20 x
1-3/4” bolts, locknuts and (4) steel washers. SEE fIGuRE 3. Bolts
must go through two holes in armrest straps. Armrest straps
must wrap around back side of seat upright weldments.
Figure 3
Figure 2
Figure 1
front platform
rear platform
1/4-20 x 2" bolts
steel washers
locknuts
platform J-pipes
1/4-20 x 2-1/4" bolts
steel
washers
locknuts
tree blade
weldment
1/4-20 x 2-1/2" bolts
locknuts
seat upright
weldments
seat upright
loop
1/4-20 x 1-3/4" bolts
1/4-20 x 1-1/2" bolts
steel washers
armrest straps