Rivers Edge RE619 LumberJack Extrme - Manual (Page 29)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 29
Operator's Manual
Rivers Edge One-Man Ladder Stands
6. Attach the upper tree blade weldment (410004) and the (2) seat
pivot brackets (410008) to the seat upright weldments using (4)
provided 1/4-20 x 2-1/4” bolts and locknuts. SEE fIGuRE 4.
7. Attach -preassembled mesh seat with fabric rail mounts (360020)
and (2) seat cables (48218) to the outside of the welded seat
frame (410071) using (2) provided 1/4-20 x 2” bolts, (2) 1/4-20
x 2-1/4” bolts, (4) locknuts and (4) steel washers. SEE fIGuRE 5
AND 6. MESh fABRIC IS NOT ShOWN TO IlluSTRATE NECES-
SARY hARDWARE.
notE: Fabric rail mounts will fit tightly around the welded seat
frame intentionally to correctly tension the mesh seat; this is
normal. the use of a rubber mallet may be needed to fully posi-
tion the fabric rail mounts onto the welded seat frame.
8. Attach the assembled seat section to the previously assembled
seat pivot brackets using (2) provided 1/4-20 x 2-1/4” bolts,
locknuts, steel washers and nylon washers. SEE fIGuRE 6. Nylon
washers should be placed between fabric rail mounts and seat
pivot brackets.
9. Attach the loose ends of the two seat cables to the seat upright
weldments using (2) provided 1/4-20 x 1-1/2” bolts and locknuts.
SEE fIGuRE 6.
Figure 6
Figure 5
Figure 4
upper tree blade
weldment
1/4-20 x 2-1/4" bolts
seat pivot brackets
locknuts
fabric rail mounts
1/4-20 x 2-1/4" bolts
1/4-20 x 2" bolts
steel washers
locknuts
seat cables
1/4-20 x 1-1/2" bolts
assembled seat section
1/4-20 x 2" bolts
locknuts
1/4-20 x
2-1/4" bolts
seat cables
nylon washers
seat frame