Rivers Edge RE619 LumberJack Extrme - Manual (Page 17)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 17
Operator's Manual
Rivers Edge One-Man Ladder Stands
Figure 3
seat cushion
9" camo shelves
18" camo sleeve
shooting rail
1/4-20 x 3-1/4" bolts
steel washers
shooting rail mounts
1/4-20 x 3" bolts
support braces
locknuts
top platform section
locknuts
1/4-20 x 2-1/4" bolts
4-step ladder section
w/ mounting holes
4. Insert the assembled top platform section into the top ladder section with
mounting holes (SL54). Attach the (2) support braces (48064) to the outside of
side rails, foot platform and 4-step ladder section with mounting holes using
(2) provided 1/4-20 x 3-1/4" bolts, (2) 1/4-20 x 3" bolts, (2) 1/4-20 x 2-1/4" bolts,
(4) steel washers and (6) locknuts. SEE fIGuRE 3. You must now tighten all
nut & bolt assemblies. Be sure not to over tighten or crush tubing when
tightening!
5. Attach the removable seat cushion (48819) to the top of seat frame. Wrap
the Velcro seat straps or buckle straps around seat frame and secure
together. Snap the side release buckles together for buckle style seats. Pull
straps tight so seat is not loose.
6. a. Attach the shooting rail (SR10) by setting rail down over studs on shooting
rail mounts. SEE fIGuRE 3. lubrication is recommended to prevent
binding and noise.
b. Attach the (2) provided 9" camo arm pad/shelves to the armrests and (1)
18" camo foam pad to the shooting rail by wrapping around metal tubing
and attaching Velcro together. Shelves should lay out flat to the outside of
armrests. Use these shelves for holding various hunting gear items so they
are readily available to you during your hunt.
7. The remaining (3) ladder sections are assembled to the top ladder assembly
on the ground in the following order: bottom section (SL51 ladder); second
section (SL52 ladder); third section (SL51 ladder); fourth section (SL54
ladder); top section (assembled top platform section). SEE fINIShED 22'
TIMBERShOT EXTREME lADDER.