Rivers Edge RE619 LumberJack Extrme - Manual (Page 24)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 24
Operator's Manual
Rivers Edge One-Man Ladder Stands
Figure 6
SWIvEl SEAT ASSEMBlY INSTRuCTIONS
notE: Swivel seat assembly must be assembled on the ground. do not
attach to platform until ladder is uprighted, attached to the tree per Set-up
and use instructions, and you are attached to the tree with the provided
Full body harness.
11. Attach swivel (48662) to either end of seat post (TP11) using (4) provided
1/4-20 x 3/4” bolts and locknuts. SEE fIGuRE 6.
notE: Make sure head of bolts are on swivel side and nut on bottom of
seat post plate to prevent any obstruction when swivel is pivoted during
use.
12. Attach seat frame (TP154) to swivel using (4) provided 1/4-20 x 1-1/4” bolts
and locknuts. SEE fIGuRE 6.
notE: Make sure head of bolts are on swivel side and nut on top of seat
frame to prevent any obstruction when swivel is pivoted during use. Mesh
surface should be on top.
13. Attach backrest rim (TP165) to tabs of seat frame using (2) provided 1/4-20
x 1-1/4” bolts and locknuts. SEE fIGuRE 6.
14. Attach the (2) armrests (TP164) to the seat frame and backrest rim using (4)
provided 1/4-20 x 2” bolts, locknuts and steel washers. SEE fIGuRE 6. You
must now tighten all nut & bolt assemblies. Be sure not to over tighten
or crush tubing when tightening!
notE: the armrests are approximately 1” longer on one side. bolt the
longer side to the backrest rim and the shorter side to the seat frame.
15. a. Attach the removable seat cushion (48127) to the top of seat frame. Wrap
the Velcro straps or buckle straps around seat frame and secure together.
Snap the side release buckles together for buckle style seats. Pull straps
tight so seat is not loose.
b. Attach the removable backrest cushion (48128) by sliding pocket portion
over the metal backrest frame. Wrap the Velcro straps around backrest
crossbar and secure together. Pull tight so backrest is not loose.
c. Using a rubber mallet, tap in (2) plastic pipe plugs (48869) into each end
of the shooting rail.
d. Attach the (2) provided 9” camo sleeves (48736) to the armrests and the
(1) 128” camo sleeve (48129) to the shooting rail by wrapping around metal
tubing and attaching Velcro together.
e. Attach the camo curtain (48086) to the shooting rail/platform by wrapping
top edge around padded shooting rail and attaching Velcro together.
Zippered door should be aligned with the ladder. Pull the bottom edge
with elastic down and secure Velcro straps around platform frame.
1/4-20 x 2"
bolts
steel washers
armrests
backrest rim
seat frame
1/4-20 x 1-1/4" bolts
swivel (shown apart)
1/4-20 x 1-1/4"
bolts
1/4-20- x 3/4" bolts
locknuts
seat post