Rivers Edge RE619 LumberJack Extrme - Manual (Page 40)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 40
Operator's Manual
Rivers Edge One-Man Ladder Stands
fOR RE623 ONlY: hOISTING YOuR SWIvEl SEAT
9. Using the three point contact climbing method, slowly descend the ladder
and carefully keep a constant hand grip on the ladder at all times until you
reach the ground.
10. Tie one end of your hoist rope (not included) to the seat assembly. Be sure
your double knot is secure. Place (4) 1/4-20 x 1-3/4” wing bolts in your
pocket.
11. With other end of hoist rope, use the three point contact climbing method
to slowly climb the ladder and carefully keep a constant hand grip on the
ladder at all times. Once you reach the platform, immediately attach
your harness tether to the tree. SEE fIGuRE 8.
12. Carefully raise the seat assembly to the platform using the hoist rope (SEE
fIGuRE 8) and place seat post on top of the platform and align the 4 holes in
seat post plate to the 4 holes located in the center of the platform. Remove
(4) wing bolts from your pocket and use them to secure the seat post/seat
assembly to the platform. Wing bolts should be inserted from the top and
threaded into the nut welds located on bottom side of platform. TIGhTEN
SECuRElY BY hAND, SEE fIGuRE 9.
13. Reverse setup and use instructions to take ladder down.
Figure 8
Figure 9
hoist rope
seat
assembly
seat
post
1/4-20 x 1-3/4" wing bolts