Rivers Edge RE619 LumberJack Extrme - Manual (Page 18)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 18
Operator's Manual
Rivers Edge One-Man Ladder Stands
8. Attach the truss support (48023) to where the second and third ladder
sections have been slid together, using (2) provided 1/4-20 x 1-3/4” wing
bolts and wing nuts. SEE fIGuRE 4.
9. a. Attach the counter lock support bar (48025) to the truss support mounting
bracket using (1) provided 1-3/4” spring lock pin. SEE fIGuRE 4.
b. Attach the opposite end of counter lock support bar and the stabilizer
bar extension tube (1ML23) to the second ladder section mounting bracket
using (1) provided 2-1/2” spring lock pin. SEE fIGuRE 4.
notE: pin may have a tight fit. this is normal due to the counter lock
support bar acting as a locking bar. You may need to temporarily loosen
the wing nuts/bolts on truss support to help with hole alignment.
Retighten wing nuts/bolts when complete.
c. Slide the stabilizer bar (L17) into the extension tube and attach the two
pieces together using (1) provided 1-3/4” spring lock pin. Spring lock pin must
go through both the extension tube and the stabilizer bar at appropriate hole
to achieve desired distance from tree. Adjustment in length may be needed
when ladder is uprighted later in instructions. SEE fIGuRE 4.
Figure 4
stabilizer bar
extension tube
spring lock pin
third ladder section
1-3/4" wing bolts
second ladder section
2-1/2" spring lock pin
second ladder
section mounting
bracket
truss support
spring lock pin
truss support mounting bracket
wing nut
counter lock support bar
10. Insert the (4) truss male braces (48041) into the (4) truss female braces
(48040). Have the flattened end of the braces oriented in opposite directions
of each other and align the holes to secure the braces together using (4)
provided 1/4-20 x 1-1/4” bolts and locknuts. SEE fIGuRE 5 ON fOllOWING
PAGE. Tighten securely, being careful not to over tighten or crush
tubing!
notE: You must be sure to have the flattened ends of braces oriented in
opposite directions of each other so they will align properly (flush) to the
mating parts later on in assembly.
11. a. Attach (2) assembled braces to where the fourth ladder section and
assembled top platform section have been slid together using (2) provided
1/4-20 x 1-3/4” wing bolts and wing nuts. You must attach the flattened end
of these braces so that it will cause them to angle away from the ladder,
towards the rounded end of truss support. It is recommended to position the
female end of these upper brace assemblies to the top of the ladder so water
will drain freely during use. SEE fIGuRE 5 AND 6 ON fOllOWING PAGE.