SKC Limited AirChek 3000 Deluxe Pump Operating Instructions - Manual (Page 18)

Page 16 210-3311M Issue E www.skcltd.com
Getting Started
1) Charging the Battery Pack
Prior to first use the battery pack should be fully charged, ideally overnight. Note that a new battery pack may
require 2 - 3 charge / discharge cycles to achieve full capacity.
The AirChek 3000 pump must only be charged using the correct SKC chargers (Part Nos. 223-240A - single
fast charger, 223-109A - five station charger).
The chargers are supplied with mains input plugs suitable for use in the UK, Europe, USA and Australia / New
Zealand. Select the correct mains input plug and fit it to the charger as detailed in the instructions supplied
with the charger.
Use a finger nail to flick open the battery pack charging socket cover at the rear of the pump. Alternatively use
the large bladed screwdriver attachment of the supplied toolkit to flick open the cover.
Plug the charger output plug into the mating socket revealed behind the charging socket cover. Plug the
charger into the electrical mains supply and switch on the power. The LED indicator on the charger will
illuminate to indicate that the battery pack is connected and charging has commenced.
Refer to the instructions supplied with the specific charger model for details of the charging sequence.
When fully charged disconnect the charger plug from the battery pack and close the charging socket cover.
To check the battery charge state wake the pump from SLEEP mode by pressing any of the three buttons on
the keypad and the LCD screen will activate, displaying the battery status indicator.