SKC Limited AirChek 3000 Deluxe Pump Operating Instructions - Manual (Page 37)

www.skcltd.com 210-3311M Issue E Page 35
7. Press the button once and the delayed start time minutes value will start to
flash. Use the and buttons to enter the required delayed start time minutes
value.
8. To save the new sample run time and delayed start time settings, press the
button until the ‘End’ screen is displayed. Press [ ] to save the setting and
switch to HOLD mode.
9. Alternatively to exit the User Interface without saving the changes, press the
button until the ‘ESC’ screen is displayed. Press [ ] to switch to HOLD mode
without saving the changes.
10. Having successfully saved a sample run time and start delay time, and switched
to HOLD mode, the run time screens will show the ‘ PROG’ icon. If the elapsed run
time is not showing zero, it is recommended to reset the accumulated run time
data. Refer to User Interface Level Two 7) on page 37.
11. At the next occurence of the programmed delayed start time the pump will
automatically switch to RUN mode and commence sampling. The elapsed run
time screen will display the accumulated sample run time.
12. At the end of the sample run time the pump will automatically switch to HOLD
mode, and the ‘ PROG’ icon will no longer be displayed on the run time data
screens.
User Interface Level Two