IAI America RCM-E - Manual (Page 71)

63
Appendix
(Note) Unless the software was reset, the parameters were rewritten to factory-installed
parameters, however, operation is not performed with factory-installed parameters.
The parameters are enabled after the next reset or after power is turned on.
Soft Reset A. 00
* Srv OFF? Y Æ 1 N Æ 0
When servo is turned ON, you are asked whether
servo off is carried out or not on all screens by
pressing the
key.
(When interrupting the software reset, press the
key. The screen returns to the mode select screen.)
Soft Reset A. 00
* Please Wait.
A message “data being obtained” appears, the
software is reset, and operation is performed with
parameters set at shipment from factory.
After executing, the screen returns to the mode select
screen.