LevelOne WHG-1000 - Manual (Page 27)

WHG-1000 300Mbps Wireless PoE Hotspot Gateway
User's Manual
27
4.1.3 Configure WAN Traffic
The section is for administrators to configure the control over the entire system’s traffic though the WAN interface
(WAN1 and WAN2 ports).
 Traffic Setup :
 Primary WAN Interface : Select desired primary WAN interface for system.
 Traffic Mode : There are three types : None, Load Balance and Backup.
 Load Balance : Outbound load balancing is supported by the system. When enabled, the system will
allocate traffic between WAN1 and WAN2 dynamically according to designed algorithms based on the
Bandwidth.
 WAN1 Max. Bandwidth : Specify the maximum download and upload bandwidth that can be
shared by clients of the WAN1 port.
 WAN2 Max. Bandwidth : Specify the maximum download and upload bandwidth that can be
shared by clients of the WAN2 port.
On the Load Balance traffic mode, the primary WAN port is WAN1. When the WAN1 connection is down,
the WAN2 will backup automatically.
 Backup : When primary WAN interface is WAN1 and WAN2 is available, WAN1's traffic will be routed
to WAN2 when WAN1 connection is down. When WAN1 connection is up, the route traffic will be
connected back to WAN1 automatically.
 Connection Detect : The connect detect sets the WHG-1000 Device to continuously ping a user defined IP
address (it can be the Internet gateway for example). If it is unable to ping under the user defined constraints,
the WHG-1000 device will change Primary WAN interface to secondary WAN interface automatically . This
option only for “Load Balance” or “Backup” traffic mode.