LevelOne WHG-1000 - Manual (Page 43)

WHG-1000 300Mbps Wireless PoE Hotspot Gateway
User's Manual
43
4.2.3.1 Configure Virtual AP
For each Virtual AP, administrators can configure general settings and security type.
Click Wireless
→ Virtual AP, click “Edit” of Virtual AP List and then Virtual AP Configuration page appears.
 ESSID : Extended Service Set ID indicates the SSID which the clients used to connect to the VAP. ESSID will
determine the service type of a client which is assigned to the specified VAP.
 Enable AP : By default, it’s “Disable” for VAP1 ~ VAP7. The VAP0 always enabled.
Select “Enable” to activate VAP or click “Disable” to deactivate this function
 Hidden SSID : Select this option to enable the SSID to broadcast in your network. When configuring the
network, it is suggested to enable this function but disable it when the configuration is complete. With this
enabled, someone could easily obtain the SSID information with the site survey software and get unauthorized
access to a private network. With this disabled, network security is enhanced and can prevent the SSID from
begin seen on networked.
 Client Isolation : Select Enable, all clients will be isolated from each other, that means all clients can not reach
to other clients.
 WMM : Select Enable, the packets with QoS WMM will has higher priority.
 IAPP Support : Inter Access-Point Protocol is designed for the enforcement of unique association throughout a
ESS(Extended Service Set) and for secure exchange of station's security context between current access point
(AP) and new AP during hand off period.
IAPP only used on WAP2 security type. Only one of VAPs can be enabled
 Maximum Clients : Enter maximum number of clients to a desired number. For example, while the number of
client is set to 32, only 32 clients are allowed to connect with this VAP.