Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual User Manual
Page 110
Teledyne LeCroy
Timer
98
Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual
Figure 5.48: Starting and Resetting Global and Sequence State Timers
Note:
Listed below are some of the considerations to note about timer functionality
1. If a timer is reset, it will restore to it's original value, in this case the value defined by
the user.
2. Resetting a timer will stop it and set it to it's original value.
3. Local timers for a particular state will automatically reset if the sequencer advances
to another state. Example: "Timer A" in State 1 and "Timer A" in State 2 are different
timers not related to each other.
4. Local timers are controlled by events defined in the same state where the timers are
defined.
5. In case of competing actions to control global timers using the same event from
global and local states, the control from local states takes priority.