Vestil PM-SCALE - Manual (Page 20)

12
Selection: 0…FS(Factory default 10d)
F2.2.4 – Minus Tolerance
Selection: 0…FS(Factory default10d)
F2.3 – APW Enhancement(F2.1 is set to Counting)
Selection: On,OFF(Factory default)
F2.10 – F2 reset to Factory default
All F2 parameters will be set to Factory default.
F3 – Terminal
F3.1 – Display
F3.1.1 – Timeout
Selection: 0, ~
10 999 seconds (Factory default 60s) 0 will disabled this
function.
F3.1.2 – Brightness
Selection: Lo(Factory default) - Low bright
HIGH - High bright
Recommend to set Low if you use battery to operation.
F3.2 – Auto power off
Selection: 0, 5 ~
60 minutes (Factory default 5 minutes) 0 will disabled this
function.
F3.3 – Battery type
Selection: drY(Factory default)
－ Dry battery
ni-ÑÖx － Ni-MH rechargeable battery
LEAd-A － Lead-Acid rechargeable battery
F3.10 – F3 reset to Factory default
All F3 Parameters will be set to Factory default.
F4 – Communication
F4.1 – Connections
Selection: Print(Factory default) - Demand print
APrint - Auto print
SICS - SICS
Contin - Toledo continuous mode
F4.2 – Format
F4.2.1 – Line format
Selection: ÑÖULti(Factory default) - Multi line
SinGLE - Single line