0 install, 1 open the package, 2 electronic connect 2.2.1 open the terminal – Vestil PM-SCALE User Manual

Page 8: 2 load cell connect, 1+e xc +sen +s ig sh ie ld -s ig -se n -exc

Advertising
background image

3

2.0 Install

This part will talking about the Installation for IND221 and IND226. Please read this

chapter carefully before install.

2.1 Open the package

Open the package, And check all the parts with the checklist. Make sure no part was

damaged and missing.

Remove the terminal from

its protective package,

.

2.2 Electronic Connect

2.2.1 Open the terminal

The IND221 terminal use 4 screws to lock the front cover.

The front panel of the IND226 terminal is locked in place by four spring clips attached

to the enclosure body. To gain access to the terminal’s PCB for internal wiring and setting

switches, separate the front panel from the enclosure as follows:

Insert the tip of a flat-blade screwdriver into one of the two slots located on the bottom

of the front panel assembly and gently push in toward the enclosure. A “pop” sound is

made when the cover is released.

2.2.2 Load Cell Connect

7 Pins terminal strip.
Pin 1 - +EXC

Pin 2 - +SEN
Pin 3 - +SIG

Pin 4 - Shield

1

+E

XC

+SEN

+S

IG

Sh

ie

ld

-S

IG

-SE

N

-EXC

Advertising