Vestil PM-SCALE - Manual (Page 21)

13
F4.2.2 – Print format
Selection: StAndr(Factory default)- Standard
OVEr - Over/Under
Count - Count
F4.2.3 – Print languages
Selection: EnG(Factory default) - English
CHn - Chinese
F4.2.4 – Add Line Feed
Selection: 0~9 (Factory default 3)
F4.2.5 – Auto print threshold
Selection: 0 ~ FS (Factory default10)
F4.2.6 – Auto print reset threshold
Selection: 0 ~ FS (Factory default10)
F4.3 – Com1
F4.3.1 – Baud rate
Selection: 1200 ,
2400
,
4800
,
9600(Factory default),19200
F4.3.2 – Data bits/Parity
Selection: 7-odd - 7 bits odd parity
7-EvEn - 7 bits even parity
8-nonE(Factory default)- 8 bits none parity
F4.3.3 – Xon/Xoff
Selection: On - Enabled
OFF (Factory default) - Disabled
F4.3.4 – Checksum
Selection: On - Enabled
OFF (Factory default) - Disabled
F4.10 – F4 reset to Factory default
All F4 parameters will reset to Factory default.
F5 – Maintenance
F5.1 – Calibration values
F5.1.1 – Zero Counts
F5.1.2 – Middle load weight (half capacity)
F5.1.3 – Middle load counts
F5.1.4 – Full load weight