ADTRAN 3000 - Manual (Page 30)

Chapter 2. Setting Up the Express 3000
2-2 Express 3000 User Manual 61203153L2-20
WINDOWS INSTALLATION PROCEDURE
The following Step/Action tables provide step-by-step instructions
for installing the Express 3000. However, the basic installation proce-
dure is as follows:
1. Connect and power up the hardware (see page 2-2).
2. Install the Express 3000 into the operating system (see page 2-3).
3. Install the Express Configuration software (see page 2-4).
Connecting the Hardware: Windows
As the first step in getting your Express 3000 up and running, install
the hardware. To ensure success, closely follow the instructions be-
low—particularly those relating to installing the cables.
Windows Instructions for Connecting the Hardware
Step Action
1 Connect the Express 3000 to the PC:
With the computer’s power off and using an appropriate serial
cable (this serial cable is not provided—see Table 1-1 on
page 1-3), connect the EIA-232 port on the Express 3000 to
an available COM port on the computer.
2 Power on the Express 3000:
Plug the Express 3000 power supply cord into the port on the
unit labeled
PWR. Plug the other end into an electrical outlet.
The Express 3000 is now powered on.
3 Connect the Express 3000 to the ISDN line:
Plug the large (RJ-45) end of the provided ISDN cable into the
jack on the rear of the Express 3000 labeled
ISDN; plug the
small (RJ-11) end of the same ISDN cable into the ISDN
telephone wall jack.
4 Power on the computer.
5 Insert the provided Express 3000 CD-ROM into the
CD-ROM drive.