ADTRAN 3000 - Manual (Page 45)

Chapter 3. Using the Express Configuration Program
61203153L2-20 Express 3000 User Manual 3-5
FACTORY DEFAULT SETTINGS
The factory default configuration settings suffice for most applica-
tions. However, you can change these settings to create custom config-
urations using ISDN and User profiles (see Understanding Profiles on
page 3-6). You can also restore these settings at any time.
Restoring Factory Default Settings
To restore the Express 3000 to the factory default settings, follow the
steps below:
USING ON-LINE HELP
The ADTRAN Express Configuration program includes on-line help.
You can access this help in two ways:
1. Click on Help in the left panel of the ADTRAN Express Configu-
ration window.
OR
2. From any dialog box, click the What’s This? button ( ) in the
top, right-hand corner of the dialog box, and then click again
over the item in question.
Instructions for Restoring Factory Default Settings
Step Action
1 Set DIP switch 2 to the OFF (Up) position.
2 Disconnect the Express 3000 from the power source.
3 Reconnect the power source for the Express 3000.
4 When the PWR LED flashes, set DIP switch 2 to the
ON (Down) position. (See also
Setting the DIP Switches on
page 2-9)