ADTRAN 3000 - Manual (Page 34)

Chapter 2. Setting Up the Express 3000
2-6 Express 3000 User Manual 61203153L2-20
Connecting the Hardware: Macintosh
Macintosh Instructions for Connecting the Hardware
Step Action
1 Connect the Express 3000 to the Macintosh:
With the Macintosh’s power off and using a Macintosh high-
speed modem cable (not provided), connect the EIA-232 port
on the Express 3000 to an available communications port on
the Macintosh.
Macintosh high-speed modem cables are avail-
able at any electronics store that carries Macintosh
equipment.
2 Power on the Express 3000:
Plug the Express 3000 AC power cord into the port on the
unit labeled
PWR. Plug the other end into a 120 V electrical
outlet. The Express 3000 is now powered on.
3 Connect the Express 3000 to the ISDN line:
Plug the RJ-45 connector (large end) of the provided ISDN
cable into the jack on the rear of the Express 3000 labeled
ISDN; plug the RJ-11 connector (small end) of the same
ISDN cable into the ISDN telephone wall jack.
4 Power on the Macintosh.