AMX Wireless Touch Panels (Wave Server) - Manual (Page 180)

170 Firmware Upgrade ViewPoint Wireless Touch Panels
Configuration
To configure the communication setting for the SOFTROM program:
1. Press F1 and the screen in Figure 225 appears.
2. Using the up/down arrow keys, select the communications port you are using to
interface with the controller and press ENTER.
3. Using the right arrow key, move to the BAUD RATE column. Then use the
up/down arrow keys to select the interface communications speed.
4. Press ENTER.
5. Press F10 to save the communication settings and to exit the CONFIGURE
screen.
Downloading the Firmware
To download the firmware:
1. Press F5 to acquire the list of online programmable devices.
2. Using the up/down arrow keys, select your firmware versions listed in the
Firmware column of the screen, and press ENTER.
3. Using the Tab key, switch to the ONLINE MASTERS list.
4. Using the up/down arrow keys, select the device to be programmed. Press
ENTER for each device as it is selected
5. Press F4 to program the selected device; a loading message (Figure 226) appears
on the screen
Figure 225
Configuration screen
Note
Make sure that the BAUD
RATE selections match the
setting on the AXCESS
System Central Controller.
Note
You can press F2 to select all
ONLINE programmable
devices and F3 to clear all
devices.