AMX Wireless Touch Panels (Wave Server) - Manual (Page 72)

62 Touch Panel Program Reference ViewPoint Wireless Touch Panels
• MIN Press the UP and DN buttons to set the minute.
• DAY Press the UP and DN buttons to set the day.
• SECOND Press the UP and DN buttons to set the seconds.
• DISPLAY MONTH/DAY, DAY/MONTH Press to toggle the order of the
month and day display.
• DISPLAY 12:00/24:00 Press to toggle the clock display to a 12- or 24-hour
format. For example, the 12-hour clock format changes from 12:00 to 1:00,
and the 24-hour clock changes from 12:00 to 13:00.
Double beep
Press the DOUBLE BEEP button (Figure 84) to toggle the double beep ON or OFF.
The double beep sounds each time you press the screen.
Set the BEEP button (described earlier) to 0 to disable the double-beep sound.
AXlink, output resolution, vX.XX, and serial number
The AXlink, OUTPUT RESOLUTION, vX.XX, and SERIAL # buttons shown in
Figure 85 are information buttons (display only).
The AXlink button is an AXCESS communication indicator that blinks once every
second when the Central Controller is connected to the touch panel. The OUTPUT
RESOLUTION button shows the screen resolution. The vX. XX button shows the
current firmware version installed in the touch panel. The SERIAL # button shows
the serial number for the touch panel.
Setting brightness
Press the SET BRIGHTNESS button in the Setup page to open the page shown in
Figure 86.
Figure 84
DOUBLE BEEP button
Note
You can set the beep value
using the 'ABEEP' and
'ADBEEP' Send_ Commands
described in the AXCESS
Programming section. The
'QBEEP' command is used for
overriding.
Figure 85
AXlink, OUTPUT RESOLU-
TION, vX.XX, and SERIAL #
button examples