Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 28)

28
‹ Wiring
indicates a fuse.
• For 4-wire cabling, “ output A’ ” is not connected.
• The power for the analog module should be supplied separately from the LT. Turn
the analog module on before turning the LT on. Wait at least 30 seconds after
power-off to restart the external power-supply or it may not operate properly.
• Connect an appropriate fuse for the applied voltage and current draw, at the position
shown in the diagram.
• Do not connect any wiring to unused channels.
This wiring diagram is for inputs configured for measuring temperature.
<EXM-AMI4LT>
+
0V
A
B’
A
B’
B
A
B’
A
B’
This wiring diagram is for inputs configured for measuring voltage/current.
+
0V
NC
IN 0
NC
IN 1
0V
NC
IN 2
NC
IN 3
<EXM-AMI4LT>