Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 30
30
*1 Total input system transfer time = sample repetition × 2 + 1 scan time.
*2 The 12-bit data (0 to 4095) processed in the Analog I/O module can be linear converted to a value
between -32768 and 32767. The optional range designation and analog I/O data minimum and maximum
values can be selected using data registers allocated to analog I/O modules.
*3 If the input data is not in the range, the error code RGEF130 (Input data error) is output for the analog
module. Once the error occurs, input data from the point of the error is no longer updated. For more
information about error codes, read the “Maintenance/Troubleshooting Guide”.
*4 The input value may be regarded as "Input Data Out of Range" due to the total maximum deviation even
when it is in the specified input range. Before inputting the value, therefore, consider the total maximum
deviation.
Selection of Analog Input Signal Type
Using software programming
It is possible to use Pt100 and Pt 1000’s
probe.
Calibration or Verification to Maintain
Rated Accuracy
Approximately 10 years
Default input value in case of temperature
sensor disconnection
Upper limit
External Connection
2 x 13-pin terminal connector
1 x 2-pin power supply screw terminal block
EXM-ARI8LT