Proface APL3000B - Node Box PC User Manual
Page 7
• After hardware setup is completed, the OS (Windows
®
XP) must be used to create
partitions and format (initialize) the HDD before any data or applications can be
saved to the PS-A drive. For details concerning these procedures, refer to the OS
manufacturer’s instruction manual.
• Whenever you turn the PS-A unit’s power OFF, wait until the internal HDD stops
spinning (approximately 5 seconds) before turning the power ON again.
• The PS-A’s hard disk is designed for use with the Windows
®
XP. Other operating
systems do not support this driver software, etc.
6
PS-A with pre-installed OS
1
Connect peripheral devices and wiring
to the PS-A unit. Connect a commer-
cially available USB keyboard to the
PS-A.
PS-3650A/3651A Hardware Manual
3 Hardware Installation
2
Turn the PS-A’s power ON.
Set the power switch on the rear of the PS-A to ON.
3
To change the BIOS settings, go to the
system setting screen. Skip this step
when you use the factory (default) set-
tings.
2.1 System Setup Screen Operation (page2-2)
4
Set up the pre-installed OS.
5
Install the PS-A unit.
•
Use of an uninterrupted power supply is recommended to protect your data from accidental
power failures. An uninterrupted power supply that supports Windows
®
will give you sufficient
time to shut down your system safely by changing into the power supply for the backup in case
of a power failure, and can even be set up to automatically shut down your Windows
®
OS.
The PS-A unit, however, cannot be used with a 2-Step Inverter Output type uninterrupted power
supply. Be sure the unit is a sine-output type power supply. For details, consult your local UPS
system dealer.
SEE
SEE
SEE