Proface FP3900 - 19 Flat Panel" - Manual (Page 62)

Chapter 6 Setting up and Adjusting the FP unit
6-5
(2) Main Menu
„Using the OSD
Icons on the screen are used to operate the OSD.
When you start up the OSD, the top menu displays.
Touching the icon of the item you want to adjust
displays its submenu or setting change screen. In the
setting change screen, icons are used to
change the setting. To set the setting, press the
button. Press the button to save the
defined settings.
„Quitting the OSD
To quit the OSD, press the or button
in the top menu or leave the OSD as it is for at least
30 seconds.
“Ver.*.**” indicates the version of the OSD.
• In the OSD, pressing the button applies the set value and enables the
setting. The set value won't be canceled unless the power is turned OFF or
the value is reset.
If the power is turned OFF without saving the set value, that data will
disappear. The last saved data will be read into the system when the FP
starts. To enable the changed value, be sure to press the button.
• All the setting values, even though in process of the OSD settings, will be
retained in condition of letting the OSD leave more than 30 seconds or by
pressing the button. The OSD will keep those values and make them
effective until power-off or a Reset command input.