PreSonus StudioLive AI Series - Manual (Page 47)

4 Universal Control-AI and VSL-AI
4.9 Smaart System Check Wizards
StudioLive ™ AI Software Library
Reference Manual
43
10. Click Analyze to generate the second frequency-response trace.
11. Place your microphone in a different off-axis position in front of the same
speaker. See Section 4.9.5 for tips in choosing the best secondary mic positions.
3
12. Click OK when your microphone is properly placed.
13. Click Analyze to generate the third frequency-response trace.
14. Adjust the EQ to shape the frequency response into the correct
trend for your application. (See Sections 4.9.6 and 4.9.7 for best
practices.) In general, you do not want to boost any frequencies
and you do not want to make any cuts greater than 6 dB.
15. Click Exit to complete the wizard.
To view the effects of your filter on the system, run the Room Analysis wizard again.
Power User Tip: In most cases, you will want to EQ the left and right side of a
stereo system the same. This is why the SRA wizard asks you to measure the left
side of your system only and linked buses are displayed as such. If you are in an
unusual situation where you need to separately EQ each side (say, you are using
a different model 15-inch speaker on the left side than you are on the right side),
connect your system to a pair of subgroup outputs and do not link them.