PreSonus StudioLive AI Series - Manual (Page 64)

5 StudioLive Remote-AI for iPad
5.2 Aux Mix Page
StudioLive ™ AI Software Library
Reference Manual
60
5.2.1 Aux Mix Select and Aux Mixing
To create an aux mix using StudioLive Remote-AI, tap anywhere in the Aux Mix Select
tab for that aux. The selected Aux Mix tab will be highlighted to alert you that its
individual channel-send levels will be displayed below.
• The Gate, Compressor, and EQ microviews function the
same for auxes as they do for channels and mains.
• Tap to open the Send Position menu to select Pre1,
Pre2, or Post fader channel sends.
• Tap the Mute button to mute the aux bus.
• Tap the GEQ button to open the GEQ for the selected Aux.
To adjust the send levels for any channel, tap anywhere in its send level and
move your finger up or down while maintaining constant contact with the iPad
screen. These send-level displays have been designed to emulate the StudioLive
Fat Channel meters while in Aux Mix mode, so they should look very familiar!
Power User Tip: The aux sends support off-axis movement. Once you have
touched a send-level control to select it, you can slide your finger anywhere on
the screen and make an up/down movement to control the send level.
5.2.2 Aux GEQ
In each Aux Bus Select tab you will find the GEQ button. Tapping this button will
open the graphic EQ for that aux.
GEQ On/Off Button. Turns a Graphic EQ On or Off.
By default, each graphic EQ is turned off. To enable
a graphic EQ, tap the GEQ On button.
Power User Tip: If you are making adjustments to a graphic EQ,
and you can’t hear your changes, make sure it is on!
GEQ Flatten Button. Sets All Graphic EQ Band Levels to 0 dB.
Draw Tool. Allows You to Draw an EQ Curve with Your Finger.
SL Remote-AI provides flexible control over your graphic EQ settings. You
can control each band individually, or several bands at once, via the sliders,
or you can simply draw in an EQ curve and fine-tune from there.
To enable EQ-curve drawing, tap the Draw button and slide your finger over the
graphic EQ bands. Each band’s slider will snap to your finger as you pass over it.
Tap the “x” in the upper right corner to close the Aux GEQ.