SABINE Graphi-Q2 3122-S User Manual
Page 10
9
B1-GRQ-2-OpGuide-v1-060519.pmd
Section Five: Installation
The Graphi-Q2 should be placed in a well-ventilated, well-grounded equipment rack, preferably within
easy reach of the sound engineer. Graphi-Q2 slave units need not be as immediately accessible, since
control is through a computer interface.
5.1. BETWEEN MIXER OUTPUT AND POWER AMPLIFIER
The most common placement of the Graphi-Q2 in a sound system is between the output of a mixing
console and the input to a power amplifier. In this configuration the GRQ2 can provide all your system
processing, including delay and crossover. A typical configuration will look like this:
This configuration can also be simplified using a single channel (one input,
using only one output) Graphi-Q2.
5.2. TWO CHANNEL GRAPHI-Q2: MAINS AND MONITORS.
Alternatively, with a two-channel Graphi-Q2, you may elect to route one mixer output through Graphi-Q2
channel A into a power amp driving your main speakers, and your mixer monitor output into Graphi-Q2
channel B, routed to your monitor speakers. This configuration is diagrammed below:
Section Five: Installation