SABINE Graphi-Q2 3122-S - Manual (Page 2)

1
B1-GRQ-2-OpGuide-v1-060519.pmd
GRQ3121 (1U, single channel, one input, two outputs)
GRQ3122 (2U, dual channel, one input & output per channel)
GRQ3121-S (1U, blank front panel slave, single channel, one input, two outputs)
GRQ3122-S (1U, blank front panel slave, dual channel, one input & output per channel)
GRQ2 Remote for Windows TM Software included with every unit; runs up to 8 Graphi-Q2s per COM port
(maximum of 2 COM ports)
• All front panel controls are analog-style; signal path is digital
• “Tweek-n-Peek” feature: Front panel adjustments of all parameters are shown in LED display screen
• 24-bit A/D and D/A conversion, 32-bit processing
• 20 to 20 KHz Frequency Response
• +18 dBV Maximum Signal Input & Output
• Floating Point SHARC Processor
• >110 dB dynamic range
Each channel provides (now with fully independent processing on 1x2 units):
• 31-band graphic EQ, with ± 6 or 12 dB range (selectable)
• Crossover: Bessel, Butterworth, and Linkwitz Reily filters; slopes to 48 dB/octave (Software only)
• High Cut Filter (3KHz to 20KHz) and Low Cut Filter (20 Hz to 1KHz)
• FBX Feedback Exterminator: up to 12 Filters, with Setup Mode (Auto Setup Mode via remote control)
• Parametric Filters: up to 12 filters, numeric or graphic control (Software only)
• Compressor/Limiter, with controls for ratio, threshold, and gain (attack, release, and knee adjustable
with remote)
• Digital Delay, with up to 1 second delay, adjustable in 20 microsecond increments
• Bypass: dedicated switches for FBX, EQ, and Delay with built in LED indicators
• LED Segmented Indicators: FBX Filters, Level, Gain Reduction
• LED Point Indicators: FBX Setup, Remote, EQ Range
• LED Character Display: Delay setting, EQ fader boost/cut, High Cut Filter setting Low Cut Filter setting,
Compressor Ratio, Threshold, Gain, and Staus Messages.
Back Panel:
• XLR & 1/4" TRS inputs & outputs
• RS-232 Serial input & output (additional serial input on the slave front panels)
• Remote switching (8-position contact closure switch; allows switch selection of all 20 stored Graphi-
Q2 presets)
Graphi-Q2 Remote Software Features:
All front panel controls, plus more, including:
• FBX filter depth & width adjustments; switchable to parametric filters (depth, width & frequency
adjustments)
• Graphic EQ filter width adjustments
• Password protection
• View & edit frequency response curves
• 20 user-defined stored presets
• Control and link up to 8 Graphi-Q2s (16 channels of audio) per COM port (1 or 2 ports can be used)
• Future-proof FREE Flash RAM upgrade capability: upgrade your firmware and software from the Sabine
website (www.Sabine.com)!
Summary of Features
S
UMMARY OF
F
EATURES
Operating Guide Version 2: for Sabine Graphi-Q2s with:
• GRQ2 Firmware Version 2.20 and up
• GRQ2 Remote Software Version 5.0 and up