SABINE Graphi-Q2 3122-S - Manual (Page 22)

21
B2-GRQ-2-OpGuide-v1-060519.pmd
S
ECTION
E
IGHT
: U
SING
GRQ2 R
EMOTE
S
OFTWARE
Section Eight: Using GRQ2 Remote Software
8.1. WELCOME SCREEN/NETWORK CHAIN SCREEN
Refer to Section Seven for instructions about installing the software and connecting your computer to
up to eight Graphi-Qs, or 16 channels of audio. You can mix the original Graphi-Qs with the new Graphi-
Q2s in a network, but the older Graphi-Qs must come after the Graphi-Q2s in the chain. If you use two
COM ports on your computer, you can set up two distinct networks of Graphi-Qs, each consisting of up
to eight units. (NOTE: one COM port chain cannot communicate directly to another, only within its own
chain.)
Double click your GRQ icon and you are presented with the Welcome Screen. You can connect to your
Graphi-Qs, or run the software off-line for editing, printing or demonstration.
Before clicking the connect button, make sure all units in your serial chain are connected properly (see
Section 7.2). When “Connect” is chosen, you’ll get a message indicating remote connection is in
progress (this may take a moment, so be patient). If the Remote Software successfully recognizes one