SABINE Graphi-Q2 3122-S User Manual
Page 12
11
B1-GRQ-2-OpGuide-v1-060519.pmd
5.5. SINGLE CHANNEL GRAPHI-Q2: ONE INPUT - TWO OUTPUTS
The single channel Graphi-Q2 also offers a unique setup option, since it offers two parallel outputs. Using
the Graphi-Q2 software, it is possible to separately assign the settings for graphic EQ filters, FBX/
parametric filters, high/low pass filters, compressor/limiter, and digital delay to either or both outputs.
Compressor/limiter and all EQ adjustments will be the same for each output, but the digital delay and
output level settings may be set individually for the two outputs. The diagram on the following page shows
a possible one-input-into-two-outputs setup.
Note: Processing is now independent on 1x2 Graphi-Q2 units. FBX, EQ, compression, and delay
settings can be unique on each output.
5.6. WHAT NOT TO DO
The Graphi-Q2 should NOT be used in the following configurations:
1.
Do NOT plug a microphone directly into the Graphi-Q2 back panel. The Graphi-Q2 is designed for
operation with line level signals only. Your microphone signal must first go through a wireless
receiver, mixer, preamp, etc. that will boost its output gain to line level.
2.
Do NOT use the Graphi-Q2 in an auxiliary or effects loop, such as would be used to add reverb to
different channels in your mixer. Effects loops are designed to split signal paths, and then mix “wet”
processed signals with the “dry” signal path. The Graphi-Q2 is designed for use as an “in line”
processor, meaning all the signal path should be routed through it.
3.
Do NOT mix balanced and unbalanced inputs and outputs to and from the Graphi-Q2. This will result
in a reduction of signal level.
S
ECTION
F
IVE
: I
NSTALLATION