SABINE Graphi-Q2 3122-S - Manual (Page 7)

6
Section Three: Front & Back Panel Views
S
ECTION
T
HREE
: F
RONT AND
B
ACK
P
ANEL
V
IEWS
Clip LED-lights
at 3 dB below
clipping Signal
LED-lights when
input is above 30
dBV peak
Phoenix block connectors
For contact closure switch RS-232 Serial In
Connect to serial port
of PC, or previous
GRQ in chain
RS-232 Serial Out
Connect to next
GRQ in chain
XLR connectors
Power connector
& fuse
Additional
RS-232 Serial In
Power On LED
FBX Section
12 filter indicators
Reset, Width,
Set, & Lock Fixed Filter
Controls
Compressor Section
Level Indicators
Ratio, Threshold, & Gain controls
Bypass Controls
Status LEDs
FBX SETUP - Fast FBX Setup
REMOTE - GRQ Remote active
EQ Range - EQ fader range indicator EQ faders
Adjust boost/cut for 31
specific frequencies
High & Low Cut Filters
Input signal &
gain reduction
indicators
Digital Delay
up & down controls.
EQ range
Press up & down buttons simulta-
neously to toggle EQ range between
+6 dB and +12 dB
Digital Delay / Tweek-n-Peek Display
Digital delay time value displayed. Also
momentarily displays current firmware at
power up, or value of any front panel
control altered.
XLR XLR XLR
G G G G GR R R R RQ3 Q3 Q3 Q3 Q3121 Bac 121 Bac 121 Bac 121 Bac 121 Back Panel k Panel k Panel k Panel k Panel
G G G G GR R R R RQ3 Q3 Q3 Q3 Q3121-S Front Panel 121-S Front Panel 121-S Front Panel 121-S Front Panel 121-S Front Panel
G G G G GR R R R RQ3 Q3 Q3 Q3 Q3121-S Bac 121-S Bac 121-S Bac 121-S Bac 121-S Back Panel k Panel k Panel k Panel k Panel
G G G G GR R R R RQ3 Q3 Q3 Q3 Q3121 Front Panel 121 Front Panel 121 Front Panel 121 Front Panel 121 Front Panel
1/4” TRS connectors
Power Switch