SABINE Graphi-Q2 3122-S - Manual (Page 35)

34
S
ECTION
E
IGHT
: U
SING
GRQ2 R
EMOTE
S
OFTWARE
2. Accessing the Stored Pre-
sets screen. This will allow
up to 20 additional user-speci-
fied memory configurations
to be stored. To open this
screen, press F6 on your key-
board, or select Stored Pre-
sets from the Options Menu.
The Stored Presets window
will open (See top of page 33).
Preset 0 will always be the sys-
tem default settings, effectively a
blank template with all param-
eters set to “off” or zero. This
configuration will permit remote
control of the Graphi-Q from any
computer meeting the minimum
requirements (see Section Seven) with the Graphi-Q2 Remote Control for Windows Software installed.
Preset 1 (FRONT PANEL) will apply only to Graphi-Q models GRQ3121 and GRQ3122, and not to the
“S” (blank front panel slave) models. In this setting, the front panel controls of the Graphi-Q2 will provide
the only means of controlling settings; any software-initiated controls will be ignored. However, any
adjustments made on the Graphi-Q front panel WILL be displayed on the Remote Control screens. In
addition, any of these adjustments, alone or in combination, can then be saved to any of the memory
locations from #2 to #20. To accomplish this, open the Stored Preset screen, and select the Program
Number/Program Name field. Type in the name you wish to give your memory, then choose SAVE. You
can rename your configuration without resaving all the parameter settings by typing a new name and
pressing the ENTER key.
If you save a program without naming it, the default name (e.g., Prog 1) will change to an all upper case
version of the same name (e.g., PROG 1).
Programs 2 through 20 will only allow remote control of the Graphi-Q2, and front panel adjustments made
when the remote control is in command will be ignored (unless you have chosen Mixed Control see section
8.2.10). Loading Preset #1 will return control to the front panel, and any physical adjustments made on
the front panel while it was disconnected will be implemented at that time.
When loading or saving configurations, the Stored Presets screen will stay open until you close it. This
allows comparisons between different configurations by loading them to active memory and auditioning
the results.
8.6.1.2. Summary of Stored Preset Protocols
To summarize the control and indicator protocols of the Graphi-Q:
1. Whenever Preset 1 is selected, the front panel settings will be absolute indicators of parameter
settings, and manual adjustments will be implemented immediately. The Remote Control screens
will display these manual adjustments, but remote control will be disabled. The Curve Display on
your monitor will indicate “Preset #1 - Front Panel in Control”.
2. Any adjustments made manually from the front panel when Preset 1 is loaded may be stored and
named in any Preset from #2 to #20.
3. Presets 2 through 20 disable front panel control, in favor of Remote Control. All settings may be
adjusted using the Remote Control software only. Updated or altered settings may be stored (using
the same or a new name) in any location from #2 to #20.
4. For Presets 2 through 20, settings made by the Remote Control will be reflected by some but not all
front panel settings (on the actual Graphi-Q unit), but all WILL be displayed on the Remote Control
screens. Adjusting the Graphi-Q front panel settings will NOT affect the audio signal, nor will the
Remote Control screens reflect these settings.
5. Changing programs can be done at any time, in the middle of an audio program if needed, PROVIDED