Seed Hawk GRANULAR AND LIQUID TANKS 2009 - Manual (Page 4)

6.0 Maintenance 36
6.1 Maintenance Schedule 36
7.0 Air Drill Monitor Introduction 37
8.0 Operation 38-46
8.1 Normal Startup 38
8.2 Normal Operate Screen 38
8.3 Changing Displayed Functions 39
8.4 Changing Display Size 39-40
8.5 Alarms 41
8.5.1 Should Be Seeding 41
8.5.2 Empty Bin 41
8.5.3 Low and High Fan Speed Alarm 42
8.5.4 Low Meter Speed 42
8.5.5 Communication Error 42
8.6 Special Start-up 43
8.6.1 Learn New System 44-46
9.0 System Settings 47-58
9.1 Installation 47
9.1.1 Install New System 47
9.1.2 Replace a Sensor 48
9.1.3 Add a Sensor 48
9.1.4 Remove a Sensor 48
9.2 Implement Setup 48
9.2.1 Units 48
9.2.2 Implement Width 48
9.2.3 Clear Field Area 48
9.3 Speed Settings 49
9.3.1 Pulses Per Rev 49
9.3.2 Wheel Pulses per 400ft 49
9.3.3 Speed Calibration & Procedure 49-50
9.4 Fan Settings 51
9.4.1 Pulses Per Rev 51
9.4.2 Low Alarm Point 51
9.4.3 High Alarm Point 51
9.5 Bin Settings 51
9.6 Meter Settings 52
9.6.1 Meter Selection 52
9.6.2 Pulses Per Rev 52
9.6.3 Low Alarm Point 53
9.6.4 Weight / Rev 53
9.6.5 Meter Calibration & Procedures 54-57
9.7 Flow Settings 58
9.8 Global Settings 58
9.8.1 Volume /Pitch 58
9.8.2 Backlight 58
9.8.3 Contrast 58
10.0 Schematics 59-61
10.1 TBH, TBT, or On-Board Hydraulics 59
10.2 Common tank Wiring Harness 60
10.3 Air Drill Monitor II 61
11.0 Warranty 62-63
12.0 Notes 64-69
13.0 Index 70