Seed Hawk GRANULAR AND LIQUID TANKS 2009 - Manual (Page 50)

Seed Hawk Manual Granular and Liquid Tanks Page 48
9.1.2 Replace a Sensor
Replace a Sensor allows you to replace a bad sensor without installing a
complete system. This refers only to Learned Sensors; i.e. Shaft Sensors, hopper
sensors, population sensors and blockage modules. Follow on-screen
instructions to perform this task.
9.1.3 Add a Sensor
Add a Sensor allows you to add a new sensor without installing a complete
system. This refers to additional sensors you may be adding to your system.
Follow on-screen instructions to perform this task.
9.1.4 Remove a Sensor
Remove a Sensor allows you to remove a sensor from the existing system
without installing a complete system. Follow on-screen instructions to perform
this task.
9.2 IMPLEMENT SETUP
9.2.1 Units
The Units setting changes the units of measure that the monitor displays:
Imperial = Acres/Feet/Miles per Hour
Metric = Hectares/Meters/ Kilometers
per Hour
9.2.2 Implement Width
Adjust accordingly to the size of your
drill
(Examples 15ft, 20ft, 30ft, 40ft, etc.).
9.2.3 Clear Field Area
Used to zero or clear your Field Acres.