Seed Hawk GRANULAR AND LIQUID TANKS 2009 - Manual (Page 57)

Seed Hawk Manual Granular and Liquid Tanks Page 55
Procedure:
1. Having Selected Meter (1, 2 or 3)
Calibration, “Target 10.0lb/ac” is
highlighted. Press the SELECT button.
Enter your desired “target” application
rate using the up/down arrow keys.
Once the desired target application
rate is set, press the SELECT button.
In the example below “Target” is set
for 100lb/ac.
2. As stated on the screen set
the gearbox on the implement
to a setting of 100 using the
increase/decrease switch on
the side mounted control box
then PRIME THE METER to
ensure full flow at the
beginning of the calibration.
Ensure diverter valve is set to
lower air stream during
calibration and reset to
proper air stream prior to
seeding.
Set at 100 for
calibration